OldGobbler

OG Gear Store
Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow

News:

only use regular PayPal to provide purchase protection

Main Menu

Long Box assistance

Started by NCStrutter, June 03, 2011, 08:39:29 AM

Previous topic - Next topic

NCStrutter

I have seen some very beautiful long boxes on this board. All are amazing.  I make standard 6-piece boxes and some half moons as well. I'd like to try some one-piece long boxes.  I have standard shop tools and I think I can do the entire box with the exception of the milling/drilling of the inside.  If possible and not too time consuming, can some offer some suggestions as to how they "work out" the inside of a long box?

In my mind, I'm thinking some sort of mill bit or a forstner bit?  I only have a small drill press so maybe this will not work ( at least the milling bit )?

Any help is greatly appreciated,

Thanks,

Jeff
"For it is in the Woods, Marshes, and Fields that Retrievers make thier own legends and become our Heroes"

Cut*N*Run

#1
Forstner bit, SHARP hand chisels, sandpaper, pocket knife, patience, and a good eye.

The hard part is keeping the angle and thickness on the soundboards consistent.

NCStrutter

Thanks C&R, appreciate the comeback.  I guess this will get me started?

Jeff
"For it is in the Woods, Marshes, and Fields that Retrievers make thier own legends and become our Heroes"

pappy

my new email is paw.paw.jack@sbcglobal.net
tel...573-380-8206