Comb riser/raiser

[FullChoke]

I went for something a little more permanent. I sanded the stock to remove the finish, rough formed a riser to be the correct height and shape and then epoxied it directly to the stock. After letting it cure for a day I sanded it smooth with the stock, sealed the wood and camouflaged the whole gun and it turned out very nicely.



FC

[the Ward]

Nice work!

[Big Jeremy]

I did similar to what a few others mentioned. I used an old camping pad that wasn't being used anymore...cut a few strips from one end and taped them on. I'll post a pic later.

[Dtrkyman]

I had a dot on a gun years ago, had to add a pad under an elastic shell holder to raise it.  Hated the set up and took it off after a season.

The burris speed bead set up is sweet.  Though I am running rifle sights now.

[Big Jeremy]

I did similar to what a few others mentioned. I used an old camping pad that wasn't being used anymore...cut a few strips from one end and taped them on. I'll post a pic later.

I added camo duct tape to it shortly after this. I have $0 invested in this...all of the stuff used was just laying around the house. Works great for me.


Sent from my iPhone using Tapatalk

[btomlin]

I had a dot on a gun years ago, had to add a pad under an elastic shell holder to raise it.  Hated the set up and took it off after a season.

The burris speed bead set up is sweet.  Though I am running rifle sights now.

I'm probably going to be in the same boat going back to just the bead.  We shall see....I'm not much for change, but thought I would give it the ol' "college try". 

[Gooserbat]

Put a Beartooth padded riser on my little 20 gauge. Helps soften recoil too.

I use one of these on one of my long-range rigs.