OldGobbler

OG Gear Store
Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow

News:

registration is free , easy and welcomed !!!

Main Menu

2 3/4”

Started by va wingbone, October 14, 2022, 01:17:09 PM

Previous topic - Next topic

va wingbone

Has anyone loaded any 2 3/4" 20ga magnum hulls with tss? I've found some primed 2 3/4" high brass hulls but every body is out of 3" hulls
"around here, turkey hunting is more like a religion than a pastime.getting close to nature, getting back to where we most belong is something we hold sacred.when we do get to take one home, we do so with reverence"

BandedSpur


Dylan730

#2
What are you trimming your 3" hull length to.  I have checked mine and the loads I got from  , I am trimming mine to 2 3/4". I was considering buying new 2 3/4" hulls if I can ever find them again. I am roll crimping.

BandedSpur

Not sure if that question was directed at me or the OP. I am loading 2&3/4" hulls with 1&5/8 oz TSS. I trim after everything is in the hull to have 1/4" of hull above the OSC for roll crimping. I am trimming off about 1/16" of hull.

troutfisher13111

Quote from: Dylan730 on October 24, 2022, 09:37:20 PM
What are you trimming your 3" hull length to.  I have checked mine and the loads I got from  , I am trimming mine to 2 3/4". I was considering buying new 2 3/4" hulls if I can ever find them again. I am roll crimping.
That is an interesting question...


Sent from my iPhone using Tapatalk

Dylan730

The question was for either of you,I am loading 1 5/8 oz of #9 tss also.  I have been trimming my 3" hulls to a little short of 2 3/4". I am using a load recipe from one of the tss suppliers and it calls for a 3" hull, but since I am basically trimming to 2 3/4", I am considering just buying 2 3/4" hulls. 

BandedSpur

Quote from: Dylan730 on October 26, 2022, 07:56:51 PM
The question was for either of you,I am loading 1 5/8 oz of #9 tss also.  I have been trimming my 3" hulls to a little short of 2 3/4". I am using a load recipe from one of the tss suppliers and it calls for a 3" hull, but since I am basically trimming to 2 3/4", I am considering just buying 2 3/4" hulls.

Should work just fine, provided the primer is the same for the 3" and 2&3/4" hulls that you are using, since you are ending up shorter than 2&3/4" after trimming.

crow

Quote from: va wingbone on October 14, 2022, 01:17:09 PM
Has anyone loaded any 2 3/4" 20ga magnum hulls with tss? I've found some primed 2 3/4" high brass hulls but every body is out of 3" hulls


yes, great patterns, Hal has load recipes for 2.75"

Reloader

I have quite a few loads that will work in 2-3/4.

Spurs Up

Quote from: Reloader on February 16, 2023, 09:10:04 AM
I have quite a few loads that will work in 2-3/4.

Yes you do!  They "work" alright. Yours are some of my favorites!