I just tried turning my first piece of it and shattered it. Don't know if it was too much pressure or too was too dull...... Just looking to get pointed in the right direction. Thanks!!
:TrainWreck1:
Scott
High speed and sharp tools. There are several types of Corian type material. The real Corian will have both sides of the material that is smooth and looks good. One side is polished more than the other. If you have one side that is polished and the other is rough, it is a lesser grade material. This material has a tendency to brake and is more brittle than original Corian. Don't try to get the corian too thin otherwise it can crack or chip while turning it. If you have any other questions about turning Corian you can shoot me a PM. I haven't done alot but I have learned alot from the stuff I have done so far. Good luck,
TRKYHTR
Thanks for the help! Speed was my problem. I was turning about 1000 rpm's. I was trying to turn it like wood.
Thanks again..... Scott
I hate the stuff, but have so much of it at the house that I cant help but use it as it was free. High speeds, VERY sharp tools, use a scraper more than a cutter, and carbide tools if you can.