OldGobbler

OG Gear Store
Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow

News:

only use regular PayPal to provide purchase protection

Main Menu

copper for trough call ?

Started by billt, January 29, 2016, 07:28:27 AM

Previous topic - Next topic

billt

what size copper should I use for a trough call
1/8 inch or 1/16 thick and how wide should it be

SS Calls


billt


misfire

I agree with Al. I have one that someone made many years ago and I remember it was a thin piece of copper
Pray as if everything depends on God, work like everything depends on you

www.misfiregamecalls.net

billt

thanks how do you condition the copper scothbrite or sand paper ?

Hersh

1/16. I usually scuff with the scotch brite pad.

SS Calls


mastevt

I really don't think thickness will matter much.  either one. as long as you have sufficient glue down making contact with the whole surface to surface contact area.  I've experimented with what happens with not enough glue to verses too much.  not enough, and you get screechy sounds, too much, and it oozes up along the edges, and you have clean up after it dries, which isn't all bad, little time consuming, but you get better sounds.  Also I've experimented with the wood contact surface.  Leaving it just plain flat and glue on the material, and machining out a slot, leaving a 1/16 edge for the surface to sit on and be glued on.  I've found no significant sound difference's.  Please keep in mind, this is in my design, and different designs might have different results.

Prohunter3509

And for neutral opinion send me one of your calls when your finished and let me try one this season.
I will give you my opinion after I use it awhile.
Lol. Hope your call is great

billt

thanks mastevt for the help I did machine a slot but left plenty of surface for glue.
I have not ordered the copper yet I have been busy with other things.
I will post pics when I can get back in the shop

mastevt

Quote from: billt on February 07, 2016, 07:19:55 PM
thanks mastevt for the help I did machine a slot but left plenty of surface for glue.
I have not ordered the copper yet I have been busy with other things.
I will post pics when I can get back in the shop

make sure you check the coppers gluing surface with a straight edge.  If its bent slightly, and you don't get a good contact
with the whole piece, it can mess up your sound.  Post up a sound file when you get it done.  I would really like to hear it.

pappy

Just my two cents worth...I use 1/8" copper glue it to a flat surface with ports drilled out under it spaced evenly through the length I make certain the layer of glue is thick enough to warrant clean up afterwards as this will ensure complete contact...also I have found that using 1" wide pieces of copper works best for me...also allows more room to work the striker across the ports....again to each their own...I think it definitely depends on the call's design...pappy
my new email is paw.paw.jack@sbcglobal.net
tel...573-380-8206

billt

thanks everyone I ordered copper will post pics soon

billt

 finally got some copper waiting for glue to dry I will let you know how it sounds
for some reason I cant post pictures it says file to large

billt

finally figured out how to post pics