OldGobbler

OG Gear Store
Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow

News:

only use regular PayPal to provide purchase protection

Main Menu

Pot call turners....

Started by southern_leo, March 11, 2018, 11:58:39 PM

Previous topic - Next topic

dejake

Once I have my blank cut and drilled, about 45 minutes on the lathe.  Probably half of that time is measuring.

ridgerunner

Take me two days from start to finish..that's from a block of wood to a call you can take hunting.

pauld

Quote from: compton30 on March 28, 2018, 06:20:03 PM
Just let me get this straight. I'm not a pot or box call maker or anything but I just like reading this stuff.

You guys can take a square piece of wood, turn it, and have it completely assembled with just waiting for the glue to dry in two hours? That just is amazing to me. Damn impressive.

From taking a board, squaring it, sanding it, laying out and drilling holes, total turning time, sand, finish, ready for glue I was averaging 35 minutes over the weekend. Lol. NOW, I break my process up and like to let the pot rest at different stages in that but.... yeh. Lol. The crazy thing is I know guys much faster and just as accurate as I am.

ridgerunner

That's amazing Paul. it takes me 35 minutes just to sand mine..let alone the other..how do you sand? what grits etc.

pauld

Sand on the lathe, low speed. 150, 220, 320, 400, 600. If you got a rough spot hit it with 100 first. Keep sand paper fresh ( its cheap), let it do the work, not you. That'll keep the heat down and keep the pot from warping.

mmclain

Quote from: ridgerunner on June 26, 2018, 08:29:04 AM
That's amazing Paul. it takes me 35 minutes just to sand mine..let alone the other..how do you sand? what grits etc.
That's way too much time!   Your heating up the wood. And most likely sanding the face Grain and end grain in an uneven rate.  Use only the top shelf sand paper cheap sand paper has poor grit quality.  After you finish cut (shear scrape) the wood.  You should not have to go below 150 grit except on some because of tear out.  150/180/220/320 is generally sufficient on most woods.  Dark woods may need finer 400/600.  The human eye can't really see a scratch pattern finer than 320 on most woods. 


ridgerunner

Quote from: mmclain on October 16, 2018, 10:47:10 PM
Quote from: ridgerunner on June 26, 2018, 08:29:04 AM
That's amazing Paul. it takes me 35 minutes just to sand mine..let alone the other..how do you sand? what grits etc.
That's way too much time!   Your heating up the wood. And most likely sanding the face Grain and end grain in an uneven rate.  Use only the top shelf sand paper cheap sand paper has poor grit quality.  After you finish cut (shear scrape) the wood.  You should not have to go below 150 grit except on some because of tear out.  150/180/220/320 is generally sufficient on most woods.  Dark woods may need finer 400/600.  The human eye can't really see a scratch pattern finer than 320 on most woods.

No i don't think i'm heating the wood up Matt or taking too much time.... I'll post a pic of one of my finished calls. then you can critique it for me.