OldGobbler

OG Gear Store
Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow

News:

registration is free , easy and welcomed !!!

Main Menu

3" pot call help

Started by Strutnut90, February 07, 2018, 04:16:42 PM

Previous topic - Next topic

Strutnut90

Hi there i started making pot calls 3 years ago and only make 3" surface calls. Theres alot of info on 3 1/2 calls but not so much on 3". Apparently 3" calls are alot less forgiving than 3 1/2. If i had known that i would of made 3 1/2s. I think they sound very good but and having issues tryinh to figure out the right width of the pedistal. I was making them only about 6mm wide and then started making them 12mm wide..but from what ive seen that still may be too small. Any help or insight would be appreciated" thanks

Strutnut90

This is the difference in the two

Strutnut90


Strutnut90


Strutnut90


Strutnut90

I understand that less surface area that the sound board is sitting on the better..so what i was thinking about doing is basically hollowing it out and leave it about a 1/4 " wide instead of having a solid pedistal.

outdoors

         ????????
NICE LOOKING CALLS
Sun Shine State { Osceola }
http://m.myfwc.com/media/4132227/turkeyhuntnoquota.jpg

noisy box call that seems to sound like a flock of juvenile hens pecking their way through a wheat field

Strutnut90

Thank you! They look good and sound good but ive found that you can never stop tweaking them to try and get that perfecf tone..

magnoliagamecalls

Can you show your chuck that is holding the middle hole of cherry call.

Strutnut90

Its a 4 jaw chuck holding a expanding mandrel. I get the mandrel from a company right here in nh that makes them for like 25 bucks works slick but unfortunately you have to have a 3/4 hole in the call as opposed to a screw chuck.

M,Yingling

i would try make that pedestal  to 1in or so round with 1/8  thick  ring get rasp out it  ,,, i use do lot 3in eather they got it or they dont
Not taking orders for calls at this time ,,,but my have some on hand  ,,,I Dont sell strikers
I do like copper pot calls,,,,Get them While u can
My YouTube
https://www.youtube.com/user/CallerTurkey

Strutnut90

Ok, 1 in isnt a whole lot..that hole in the center is 3/4 in so thats a pretty small pedistal..i just noticed that alot of calls ive seen have alot bigger pedistals..i just seemed to get a better sound with the bigger pedistal but was thinking taking the rim down to about 1/8 in like u said

M,Yingling

yes in your pics it looks like u got alot maybe to much  glue surface for your sound board
Not taking orders for calls at this time ,,,but my have some on hand  ,,,I Dont sell strikers
I do like copper pot calls,,,,Get them While u can
My YouTube
https://www.youtube.com/user/CallerTurkey

Strutnut90

The rim on the top is about 1/2 and the rim on the bottom is about 1/4in. In your opinion should i stick with the smaller or larger diameter and just trim the rim down

M,Yingling

would try trim rim down ,,, 1/8 ,,, of course it would be good know what your trying to change sound wise
Not taking orders for calls at this time ,,,but my have some on hand  ,,,I Dont sell strikers
I do like copper pot calls,,,,Get them While u can
My YouTube
https://www.youtube.com/user/CallerTurkey