So I like a glossy finish on my trumpets. Sometimes I think that call makers will wet a call to make the colors pop but it has a matte or natural finish underneath. To me a flat finish doesn't do the wood justice. Can I just coat a call that has a flat finish with a gloss finish or do I need to do some light sanding first? Actually I like the glossy Tru Oil finish used on gun stocks. I don't have a lathe but I imagine I could just rub a gloss finish on with a cloth, or I can rig up my power drill to be like a slow lathe. I trust that more than using my dremel tool like a lathe.
Sent from my iPhone using Tapatalk
Quote from: Meleagris gallopavo on December 15, 2023, 06:34:51 PM
So I like a glossy finish on my trumpets. Sometimes I think that call makers will wet a call to make the colors pop but it has a matte or natural finish underneath. To me a flat finish doesn't do the wood justice. Can I just coat a call that has a flat finish with a gloss finish or do I need to do some light sanding first? Actually I like the glossy Tru Oil finish used on gun stocks. I don't have a lathe but I imagine I could just rub a gloss finish on with a cloth, or I can rig up my power drill to be like a slow lathe. I trust that more than using my dremel tool like a lathe.
Sent from my iPhone using Tapatalk
I would sand it back to wood and start over. You might be successful with just a light sanding, but no telling what lies under the surface. Just be careful around the bell edges/opening as it can change the sound/draw of a trumpet.
I use Tru Oil, all the time, on oily woods like cocobolo, you have to put another finish on first or it will never dry. Rub a very light coat on with your fingers, let it dry, add more if needed.
Changing the finish on a horn without the right equipment can be risky and challenging to say the least. I usually use Shellack on the tropical oily wood. As stated by Greg, you do run the risk of changing the sound, be careful.