OldGobbler

OG Gear Store
Sum Toy
Dave Smith
Wood Haven
North Mountain Gear
North Mountain Gear
turkeys for tomorrow

News:

only use regular PayPal to provide purchase protection

Main Menu

cutting soundboards for potcalls?

Started by mossyhorn2, October 16, 2016, 10:38:11 AM

Previous topic - Next topic

mossyhorn2

Does anyone have a good way of cutting out soundboards? I've tried using a hole saw bit on the drill press with mixed results. Just can't figure out a good way to keep nice edges on the soundboard.

mastevt

Normally, I mill down the material in a plainer to desired thickness.  Scribe a circle using a glass soundboard, cut out using my bandsaw, then dress the edges with the disc sander on my shopsmith.  Rotating while gently holding it against sanding disc.  Sand up to pencil mark.  I've thought about even turning some material down with the lathe to desired diameter, and then cut off the desired thickness using a miter saw. Making soundboards out of wood can be a pain.

doublespurs21

  I found that when I tape down the 1/8 inch material, it does not move around when cutting it out on the drill press, (2 sided tape), and clamping the board to the table on the press. also, get a very good holesaw for your holes,,, hope that helps..

mossyhorn2

 I figured it might be one of those things that are just going to be difficult, but I do appreciate the help. Thanks for your expertise.

pappy

I cut mine on the bandsaw, it isn't hard ...
my new email is paw.paw.jack@sbcglobal.net
tel...573-380-8206

Steve

I use a holesaw to cut my wood soundboards then dress them up on the belt sander. You really have to have a trick or two when cutting them on the drill press though.

Bseckinger

I also use a hole saw on the drill press with double sided tape to attach sound board material to a sacrificial block.  I then dress the edges on a belt sander.  Be sure to clamp the block well. I have also used a 1x as a cutting guide and clamped the sound board material between that and the sacrificial block.  This has worked well for cutting aluminum.  Make absolutely sure everything is secured well!  Sheet aluminum flying around can hurt.

MickT

Anybody ever turned stock to diameter on a lathe then cut to thickness on a bandsaw?


Sent from my iPhone using Tapatalk

ridgerunner

I'll take a 3 inch hole saw cut a 3 in plug out of wood of choice, take that plug and slice it on the bandsaw, I made a jig to slice on bandsaw. piece of cake