hole size?

[Teebugg]

Whats the general consensus on hole size for the bottom of your pot calls?  And does anyone drill holes on the side?

[ky turkey hunter]

Small or few holes not as much volume as more or bigger holes I use 3/8

[TN-Hunter]

The more holes the more volume the call will let out I use 5/16 or 3/8 just depending on the call surface and the type of wood I use.

[pappy]

See a lot of 3/8" holes for the ports used in pots. Equally spaced around the perimeter, with one in the center. I use several port designs, I prefer four 3/8" and four 1/2" drilled equally spaced opposite each other. Of course this is for the dual purpose pots I make, as there is also a 1-1/2" hole in the center which acts as an access hole for the secondary striking surface.

[Teebugg]

On my chew can calls ive been using three 3/8" holes. Seems to work good. One in the center and two out to the side of it.